*To see the entire Blog, click here.
How to Install the Zipper Access Doors and Prevent Them from Leaking
Dr. Shrink’s Zipper Access Doors are tape on the finished cover to allow access into a shrink wrapped object without compromising the durability of the cover.
TRICK – To install our Zipper Access Doors, just follow these simple steps:
1.) A small piece of tape should be placed on each corner to position the door, then tape applied around the entire perimeter. You must tape all 4 sides of the door to the shrink wrap cover. Press and seal the tape to the cover. *It’s important to use Heat Shrink Tape for the best adhesion.
2.) The doors are installed after the shrink wrap has already been heated. They should be installed where there is easy access into the object and on a vertical surface.
3.) Doors should like a big “U” with the curve at the bottom. Make sure to rub out all the air bubbles and to use the Dr. Shrink Film Knife, so your cuts on the end of the tape are clean.
4.) Once the door is taped on, unzip the door and cut out the hole to access the inside of your object.
Click here for our YouTube video with instructions (starts about the 1:25 mark).
TREAT – Today Online Only we’re offering a 10% discount on our 30″ x 36″ Zipper Access Doors. Just enter promo code TREAT26 at checkout.
*This promotion expires at 11:59pm EST on 10/28/16
