Sling Shield 8″ x 600′ (SS-86006)


Helps protect a boat’s finish from marks caused by lifting slings during launch and haul-out. 6-mil white polyethylene continuous tube on a roll that has been formulated specifically for use on boat lift slings and fork lift tines.

Call 800-968-5147 to Order

Product Description

Designed to resist tearing and punctures – made with 100% virgin resin shrink wrap. Easy to keep clean – dirt and grime can just be pressure washed away.

Simple to install and only requires one person to get the job done. Shrinks with very low heat.

Sling Shield is also great for protecting sail boat masts during transportation.

*Holder not included.*

Additional Information

Weight 23.5 lbs
Dimensions 12 × 12 × 9 in
Shrink wrap can burn.
If heat is applied incorrectly, shrink wrap can ignite into open flame. It can also drop down onto other combustible material and cause secondary ignition and fire. If at any time you observe the wrap on fire immediately stop what you are doing and carefully inspect the area where you are working for a possible fire. Keep a fire extinguisher available at all times.

How-To Shrink Wrap a Rec Boat (detailed instructions)

How-To Shrink Wrap a Rec Boat (quick one-page reference sheet)

How-To Shrink Wrap a Pontoon Boat

How-To Shrink Wrap a Sailboat- Mast Up

How-To Shrink Wrap a Sailboat- Mast Down

How-To Fully Encapsulate (industrial)

How-To Shrink Wrap Modular Units

How-To Shrink Wrap for Scaffolding (general)

How-To Use the Strapping and Buckles

Vent Installation and Boat Size/Venting Chart